Owatrol D1 D1-2.5 DEKS OLJE Wood and Decking Matt Oil Saturator 2.5 Litre Less Expensive

Owatrol D1 DEKS OLJE Wood and Decking Matt Oil Saturator 2.5 Litre

Option D1-2.5

Barcode 3297971108324

2.5 Litre Trade Tin OWATROL Deks Olje D.1 is a uniquely penetrating wood oil that is high in solids and is able to get deep into the grain of woods where it dries, stays and sets.

Used on its own OWATROL Deks Olje D.1 needs occasional topping up of the surface as UV light and water wear it out.

Very easy to use coating.

Deks Olje D2, or other UV varnishes, can be directly applied on top of OWATROL Deks Olje D1 to create a long lasting deep gloss finish.

Video Demonstration

DEKS OLJE D.1 is an oil, which saturates the wood, literally feeding it with oil to replace those lost.

Driving out moisture and air, filling the wood spores with oil, it enriches and stabilises to provide long lasting protection to interior and exterior timber.

A non-film forming, clear oil DEKS OLJE D1 enhances the natural beauty of the wood while being easy to maintain, requiring no sanding or stripping.

Properties

• 2.5 Litre Trade Option Large Tin
• Optimised for thick, dense, oily and difficult to impregnate woods.
• Drives out moisture and air by penetrating deep into the wood pores.
• Protects against humidity and its effects.
• Transparent – Maintains the woods natural appearance.
• Natural matt sheen finish
• For a gloss finish topcoat with DEKS OLJED.2
• Non film forming – No peeling, No flaking.
• Easy maintenance – No stripping or sanding.
• Can be applied above and below the waterline.
• Solvent based Alkyd-Urethane Resins.
• Colour Amber.
• Setting up time before use or finishing withDEKS OLJE D.2 – 3 days depending on conditions

Basic Uses

• Exterior and Interior use – Decks, Hulls, Trim,Wheel House, Furniture.
• Horizontal and Vertical surfaces.
• Hardwoods (Exotic and Broad Leaved) – Oak,Chestnut, Iroko, Teak, Mahogany.
• Softwoods – Pine, Larch, Cedar.
• Excellent primer for conventional single pack marine coatings.

Good Application Practices

1. Always decant a small managable amount at a time into a paint kettle
2. Cover everything you do not wish to paint.
3. Apply between 5 and 35 degrees and do not apply in direct sunlight or to hot surfaces