Sika Damp Proof Slurry DPM 25kg SKDPSLUR25 Hot Selling

Sika Damp Proof Slurry DPM 25kg

MPN: SKDPSLUR25

Barcode: 5055047201021

Sika Damp-proofing Slurry is a ready to use just add water, water proofing brushable or trowelable membrane.

Its a high quality thin layer waterproof slurry coating.

Based on special cements and admixtures to provide a water and damp proof finish.

When mixed with water a slurry or mortar material is produced for direct application to a variety of construction substrates.

Sika Damp-proofing Slurry is used for:

Waterproof coating for tanking residential domestic and commercial premises basements and areas with damp issues.

Thin layer mortar or slurry coating lining for internal water-proofing damp-proofing of basement and cellar walls and floors

For interior and exterior damp proofing of basement walls in new buildings.

For interior and exterior waterproofing of concrete, renders, brickwork and blockwork structures, Lining of water tanks, pools, planters etc.

Characteristics:

Low odour compared to traditional DPM bitumen coatings

Easy to use and apply

BBA approved

Just add water

Brush, trowel or spray applied

Easy and fast mixing

Consistency can be varied to suit application method

Good adhesion

Excellent workability

Protects against water penetration

Non toxic

Layer Thickness:

1mm min. 2mm max in 1 coat.

For damp-proofing use minimum 2.0mm thickness

For waterproofing use minimum 4.0mm thickness 2 coats minimum by brush.

Coverage:

Dependent on the substrate roughness, surface profile and thickness of the layer applied.

As a guide, 2.1 kg/m2/mm excluding allowances for loss wastage, surface profile and porosity, etc.

1 unit of 25 kg yields will cover approximately 6.5-7.0m2 @ 2.0mm thickness.

Mixing:

Slurry application by brush: 4.5 4.7 Litres of water per 25 kg bag.

Mortar application by trowel: 4.0 4.25 Litres of water per 25 kg bag.

Spray application: 4.0 4.5 Litres of water per 25 kg bag.

Waiting Time and Over coating:

Apply 2nd coat within 24 hours of first coat.

Notes:

Sika Damp-proofing Slurry does not provide a trafficable finish on floors it will need to be protected with a levelling screed.

Special attention is required to avoid puncturing the waterproof coating with fixings, these should be accommodated either by surface bonding

with Sikaflex EBT adhesive or similar high bond adhesive.

Sika Damp Proofing Slurry will not bond to surfaces that have been treated previously with a water repellent.

Finishing plasters may take longer to set when applied over the Damp-proofing Slurry.

Always refer to Sika Technical Datasheet before using this product

Sika Official Information:

Sika Damp Proofing Slurry Technical Data Sheet

Sika Damp Proofing Slurry Safety Data Sheet

Sika Damp Proofing Slurry Declaration Of Performance

Manufacturer Information Page