Sika Sikabond MS Wood Floor Flooring Adhesive 600ml Box 12 FPSKBDMSFL6 Official

Sika Sikabond MS Wood Floor Flooring Adhesive 600ml Gun Grade Box of 12

Trade Product Option: FPSKBDMSFL6

Barcode: 5055492700933

SikaBond MS Wood Floor 600ml Gun Grade Foils a high quality trowel applied adhesive for bonding wooden floors to all common building substrates

whilst remaining permanently elastic thus accommodating differential movement associated with changing climatic conditions.

The formulation is completely water andsolvent free thereby eliminating the possibility of wooden block and planks warping or cupping due to VOCs.

Sikabond MS has an open time of approximately 60 minutes this makes this product also ideal for larger areas and ease of adjustability.

Benefits:

Gun grade 600ml.

Will not cause warpage or curling of wooden blocks and planks.

Bonds directly to all common subfloor materials concrete, wood, metal, ceramic tiles, vinyl, and most natural stone floors.

Suitable for use with under floor heating

Excellent gap filling properties for uneven surfaces

Full bed elastic product gives excellent sound dampening acoustic properties

Isocyanate Free

Limitations:

Do not use directly over bitumen or asphalt floors, or substrates that bleed oil or plasticizers.

Do not use, store or allow to cure below +5oC.

Do not use on wet substrates.

Ensure substrate is completely dry or SikaBond Rapid DPM has been applied.

Do not use damp proof membranes over Anhydrite / Calcium Sulphate or other Gypsum based screeds.

This product is only suitable for direct applications to clean, dry subfloors where moisture levels are below that required by the wood flooring manufacturer.

Ensure conditions are suitable for the installation of wood flooring.

Surface Preparation:

Always check moisture level of subfloor with suitable equipment and ensure that the moisture content is 2% CM or in the case of Gypsum based screed 0.5% CM.

On cement based substrates where moisture levels are above 2% CM but below 5% CM install a liquid applied damp proof membrane such as Sika Bond Rapid DPM.

All surfaces must be sound, clean, dry and free from dust, grease or other contaminants that can reduce adhesion.

Existing floors must be free from all polish and wax.

Residues of old adhesive not being isolated with Sika Primer-MB or SikaBond Rapid DPM must be removed mechanically as they may affect adhesion.

Always check and record moisture content of subfloor.

Basement/below ground floors must be adequately protected with a damp proof course and two coats of SikaBond Rapid DPM.

Further Preparation:

Turn off any underfloor heating systems 48 hours before and 48 hours after applying the adhesive.

Ensure that wood flooring is acclimatised instrict accordance with wood flooring manufacturers requirements.

Application:

Always check with flooring manufacturer re: any specific instructions/requirements specifically

Coverage:

Spread the adhesive uniformly on the sub-floor with a suitable notched trowel at no less than 0.6kg per meter square.

Do not spread more adhesive than can be covered within 20 minutes.

Place wood in position whilst adhesive is still wet, press firmly and evenly across the wood surface to ensure complete contact with the adhesive.

Ensure you leave a 12-15 mm expansion gap along the walls and around pro trusions to allow for the natural expansion of the wood.

Floor can be trafficked sanded or coated after 24 hours

Sika Datasheets:

Sikabond MS Gun Grade Safety Data Sheet

Sikabond MS Gun Grade Technical Data Sheet

Manufacturer Page

See All Wood Floor Adhesives

See All Sika Products